QuickbeamX

T. Rex Easy Print and Glue

by QuickbeamX

T. Rex Easy Print and Glue

I sliced this beautiful model up for easier printing with less support. It printed out wonderfully, but I think that you all could probably do a better job gluing than I did. I printed this with 30% infill except the arms which got 50% for a little extra strength. I used 4 perimeters and top/bottom layers (shells), but 5 in the arms. This model looks great at .1mm layer height but would probably look even better at .05mm.

File Size Updated Download Zip
TRexRightLegSupported.stl 16.9 MB 4 years, 12 months ago
Preview of TRexRightLegSupported.stl Preview of TRexRightLegSupported.stl Preview of TRexRightLegSupported.stl
177
TRexRightLeg.stl 13.2 MB 4 years, 12 months ago
Preview of TRexRightLeg.stl Preview of TRexRightLeg.stl Preview of TRexRightLeg.stl
136
TrexLeftLeg.stl 11.7 MB 4 years, 12 months ago
Preview of TrexLeftLeg.stl Preview of TrexLeftLeg.stl Preview of TrexLeftLeg.stl
167
TRexArms.stl 11.2 MB 4 years, 12 months ago
Preview of TRexArms.stl Preview of TRexArms.stl Preview of TRexArms.stl
141
TRexTail.stl 19.1 MB 4 years, 12 months ago
Preview of TRexTail.stl Preview of TRexTail.stl Preview of TRexTail.stl
136
TRexBody.stl 4.2 MB 4 years, 12 months ago
Preview of TRexBody.stl Preview of TRexBody.stl Preview of TRexBody.stl
191
TRexLeftLegSupported.stl 15.2 MB 4 years, 12 months ago
Preview of TRexLeftLegSupported.stl Preview of TRexLeftLegSupported.stl Preview of TRexLeftLegSupported.stl
156
TRexHead.stl 2.9 MB 4 years, 12 months ago
Preview of TRexHead.stl Preview of TRexHead.stl Preview of TRexHead.stl
134
TRexHeadSupported.stl 24.8 MB 4 years, 12 months ago
Preview of TRexHeadSupported.stl Preview of TRexHeadSupported.stl Preview of TRexHeadSupported.stl
133
T. Rex Easy Print and Glue by QuickbeamX is licensed under the Creative Commons - Attribution - Share Alike license.